Instructions

legend
Vertical Hinge Method
1. Position legend and hold in place with masking tape. (See Figure 1)
2. Apply masking tape vertically through the center of the legend. (See Figure 2)
3. Remove tack from one end, lay legend over towards center of tape hinge.
4. Pull release liner away from application tape and legend toward the hinge.
5. Cut release liner with scissors and discard.
6. Squeegee down exposed half legend.
7. Remove tack and hinge and lay other half over.
8. Remove the rest of the release liner and squeegee into place.
9. Remove application tape and squeegee again.

Horizontal Hinge Method
1. Position legend with tacks. (See Figure 1)
2. Apply masking tape horizontally across top of legend. (See Figure 3)
3. Remove tacks.
4. Flip legend over and remove release liner.
5. Holding both sides of the bottom of the legend, lay over sign surface.
6. Using as little pressure as possible, smooth entire legend into place with hands or squeegee.
7. Squeegee downward from hinge and increase pressure from center outward in all directions.
8. Remove hinge and squeegee again.
9. Remove application tape and squeegee again.

“Eye Ball” Method
1. Draw a baseline and either a vertical center or edge line mark on application tape.
2. Mark corresponding lines on sign surface.
3. Position legend in place by lining up markings.
4. Lightly squeegee to remove most liquid and set in place.
5. Squeegee from center outward in all directions gradually increasing pressure.
6. Remove application tape and squeegee again.